Industrial safety has evolved considerably since its beginnings in the early 20th century. The number...

Utilizing high quality pressure, load, and torque sensors, and selecting the correct design and installation...

This paper describes a new two-phase cooling heat transfer cell based on a submerged vibration-induced...

Medical electronic equipment is getting smaller. Of course, this could be said of all electronic equipment...

This Application Note was written to provide insight into the one time requirement for ‘type' testing...

A customer of Hitex was in the acquisition phase of a new project: the development of a Battery Management...

For applications requiring high power density and high power, but not requiring electrical isolation,...

While CCX has been an overwhelming success in the laptop world, few medical devices carry the Cisco Compatible...

Flash memory is commonly used to store firmware in embedded systems. Occasionally, the firmware stored...

Viking Technology manufactures DRAM modules for OEMs in Enterprise, Telecommunications and Industrial...

With the digital expansion over the past few decades, new requirements for data centers to store, transmit,...

All power supplies generate waste heat which has to be dissipated. The heating effect becomes greater...

In modern societies, a substantial amount of electrical energy is required for the operation of electronic...

Ironless rotor DC motors present characteristics highly desirable for speed and position servos. Due...