Choosing an AT or SC cut for OCXOs
The use of different crystal cuts in frequency control applications result in different performance. This paper will discuss the AT cut and SC cut performance along with cost trade-offs of the two cuts. Since the SC is primarily used for ovenized applications, this will be the focus.
The SC and AT cuts have different temperature stability curves. For comparison purposes, the chart below shows both the AT and SC.
Download this whitepaper to find out more.
Read More
By submitting this form you agree to Connor-Winfield contacting you with marketing-related emails or by telephone. You may unsubscribe at any time. Connor-Winfield web sites and communications are subject to their Privacy Notice.
By requesting this resource you agree to our terms of use. All data is protected by our Privacy Notice. If you have any further questions please email dataprotection@techpublishhub.com
Related Categories: Power
More resources from Connor-Winfield
Optimizing Timing Performance of GPS Frequency Reference
Choosing the right GPS timing solution is essential for 4G base station reliability and performance. The timing characteristics, GPS reliability wi...
Advantages and Challenges of Third-Overtone IC Crystals
ICs with on-board oscillators requiring low frequency fundamental crystals are commonplace but now IC frequency multipliers require the higher freq...
Choosing an AT or SC cut for OCXOs
The use of different crystal cuts in frequency control applications result in different performance. This paper will discuss the AT cut and SC cut ...
