MachXO™: Optimized Programmable Devices for Bus Interfaces, Bridges and Control
Bus bridging, interfacing and control are common functions in many electronic systems. The use of these functions spans virtually every end market segment, including automotive, consumer, communications, computing, industrial and military.
In many cases, designers turn to programmable logic devices, either low-capacity FPGAs or high-capacity CPLDs, to implement these functions. However, neither class of programmable logic device has offered an optimal solution that fully addresses the requirements for devices implementing these functions.
Download this whitepaper to find out more information.
Read More
By submitting this form you agree to Lattice Semiconductor Corporation contacting you with marketing-related emails or by telephone. You may unsubscribe at any time. Lattice Semiconductor Corporation web sites and communications are subject to their Privacy Notice.
By requesting this resource you agree to our terms of use. All data is protected by our Privacy Notice. If you have any further questions please email dataprotection@techpublishhub.com
Related Categories: Automotive, Communication, Embedded, Industrial, Memories, Power
More resources from Lattice Semiconductor Corporation
RELIABLE RESET GENERATION FOR TI TMS320C6XXX (“DAVINCI”) PROCESSORS
Every microprocessor or DSP requires a reset generator circuit or IC to perform two functions: (1) start up from a fixed condition after the suppli...
Pre-tested System-on-Chip Design Accelerates PLD Development
Many moderate size Programmable Logic Device (PLD) designs, especially those in control plane applications, consist of a number of interfaces inter...
CMOS to MIPI D-PHY Interface Bridge Soft IP
MIPI D-PHY is a practical PHY for typical camera and display applications. It is designed to replace traditional parallel bus based on LVCMOS or LV...